octoprint exceeding cpu power of old pi B ?
big missing gaps in print (but yet actually can see some improvements!!!)
upgrading a dangerous thing eh!
suddenly you are kung fu expert and everyone wants to challenge you LOL!
yeah, python pops up taking 49+% of cpu when octoprint using/requiring 50+ % and top taking 2%
wish I could remember which version I was running before upgrading....
that said, this is cheapest filament, notably different! (does not snap off after a few hours stationary) let me just load up some more expensive filament and retry... (though python did pop up hogging cpu it was at end of print I noticed it)
more brittle == better ?
dimensionally the piece (after a reboot after an apt upgrade and octopi upgrade, I might not have rebooted when I should) does seem good..... could be settings in cura need changing for subtleties.... hotter print for this filament, (though I suspect peak exceeded in very short burst on old pi B, might be subtleties of cura)
reprint of piece after the reboot, nothing else changed, seems better, but still gappy in print.... though final layer consistently more open....
same reason it is not stringing is same reaon very open top layer... cool enough to stop stringing, not hot enough to spread! ???