This could be a suitable replacement. And it looks as shipping to India is supported for free.
http://www.ebay.com/itm/10Pcs-TransFlas ... Sw9VZXO-Wi
As 10 pieces only cost 1€ (shipping included) it is worth a try. My guess is 30 minutes work with a soldering iron and good magnifying glass. You also get 9 spares in case you ruin it again.
My suggestion is to unsolder it first. Then apply solder on the bare pads and clean up the area with alcohol. After that put the new part in the correct place. Solder one corner to the board to keep it in place. Then heat up the pads with a clean soldering iron. No more tin. Keep the iron at 255 degrees Celcius. (Or use hot air through a very small nozzle if you have this option available.)
It is definitely worth to spend a little time in fixing this. €35 for 30 minutes of work. And you learn to work with small electronics at the same time.