I'm trying to run a brushless 750kv motor via the Rpi and I seem not to be able to do it.
I made connections as follows -
ESC - signal --> RPi gpio where i send the PWM
Positive --> left disconnected
Negative --> ground
and then i connected the esc to the motor
import RPi.GPIO as GPIO
please help. I'm at a loss what to do next.
any suggestion regarding the aforementioned will be helpful (Code or Other wise)
PS- i connected a led to the pwm port of the raspi and it blinks while when i connect the esc to the esc output it doesn't
PPS - the positive wire of the ESC is left disconnected on purpose. I followed the instructions on how to connect from this blog -->http://techvalleyprojects.blogspot.in/2 ... orial.html
and this one - https://solenerotech1.wordpress.com/201 ... pberry-pi/