I am wondering if you could add the following to it.
Location of the P1, P5 and P6 -- just the Pin 1 location from 0,0
No I can't do that.
It sounds strange but the reason is simple:
I have provided all measurements using a simple digital caliper.
If I indicate the pin-1 that information is likely to be used in PCB design.
(I think that is also the reason why you asked).
A digital caliper is not accurate enough to provide that data.
I will have to ask the foundation (especially Pete Lomas) for the
Gerber database. From there I can give figures exact enough for PCB design.
I am, not sure they are willing to give that data out.