This is maybe a newbie question and wrong thread?
I'm writing a program to run some motors and other things in python 3... for the Raspberry Pi 2 B.
I use 22 of the GPIO pins for signal out and incoming.
Somehow I would like to run the program in "simulate" mode so I can see on the screen what happens and different functions and so on and the status for the GPIO pins.
Earlier I programmed a ZEN relay system with "ladder" language and was able to simulate the program on the screen.
I would like to do the same with the Python and the Pi. The Geany does not do what I meant-want. It only steps one line but not "simulate".
Is there any program doing this?
Thank You for any suggestions.