Page 1 of 1

Does anyone use the UART pins and the SPI bus at the same ti

Posted: Sat Mar 11, 2017 1:49 pm
by fangfufu
If I put
dtparam=spi=on
in my
/boot/config.txt
, my UART pins stop working, after booting up. The login prompts don't show up. Is anyone else experiencing the same problem?

Re: Does anyone use the UART pins and the SPI bus at the sam

Posted: Mon Mar 13, 2017 6:37 pm
by edo1
I use both SPI and UART without any issue (and I2C as well)

Re: Does anyone use the UART pins and the SPI bus at the sam

Posted: Mon Mar 13, 2017 9:41 pm
by fangfufu
edo1 wrote:I use both SPI and UART without any issue (and I2C as well)
Which Raspberry Pi do you have?