User avatar
Posts: 72
Joined: Sun Jun 02, 2013 7:19 am
Location: Palm Beach County, Florida USA
Contact: Website

Display Dimensional Drawing

Thu Oct 29, 2015 2:29 pm

I prepared this new CAD model and dimensional drawing to facilitate making enclosures or panel-mounting the Raspberry Pi 7-inch display: ... nsions.pdf

This is based on (but simplified from) the official drawing at ... 092015.pdf in that it only includes the dimensions and features relevant to an enclosure or panel-mounting. It is also enhanced by showing the dimensions of the overall assembly envelope including a Raspberry Pi 2, which is critical to fitting an enclosure but not shown on the official drawing. It also adds a few missing details like the maximum screw penetration.

My drawing is also scaled 1:1, so you can print at 1:1 to cut paper templates and paste them onto your materials to readily improvise hand cuts and construction without a lot of difficult layout, or to cut out "paper dolls" for designing mechanical assemblies.

Posts: 2
Joined: Fri Nov 13, 2015 6:17 pm

Re: Display Dimensional Drawing

Fri Nov 13, 2015 6:32 pm

hi there,

i am modeling 3-d rb pi . i need basic dimensions that give the bulge shapes and processor location. where can i find.

thank you.

reply at

Return to “Official Foundation Display”