Go to advanced search

by dogman1155
Tue Aug 13, 2019 2:15 am
Forum: Automation, sensing and robotics
Topic: Using a Pi to Log Data in a Magnum Energy System
Replies: 122
Views: 50961

Re: Using a Pi to Log Data in a Magnum Energy System

I wrote my code for just the same reason you did although my system has grid power, I did not want to depend on it since I also am a ham radio operator/experimenter and wanted to have power even if the grid goes away. The system started out just to power my radios and ended up powering the whole hou...
by dogman1155
Fri Aug 09, 2019 3:33 am
Forum: Automation, sensing and robotics
Topic: Using a Pi to Log Data in a Magnum Energy System
Replies: 122
Views: 50961

Re: Using a Pi to Log Data in a Magnum Energy System

Charles thanks for the reply. I may have an older version of the magnum protocol document date Oct-15-09. I wrote my software in C back in 2010-2011 when I setup my system and it worked fine until I replaced the ME-ARC, version 2.2, controller, my software was too strict and required one of each pac...
by dogman1155
Thu Aug 08, 2019 1:15 am
Forum: Automation, sensing and robotics
Topic: Using a Pi to Log Data in a Magnum Energy System
Replies: 122
Views: 50961

Re: Using a Pi to Log Data in a Magnum Energy System

I have a Magnum system with two MS4448PAE inverters and the BMK battery monitor. I just recently upgraded from a single inverter to a dual inverter system. In doing so I had to replace the ME-ARC monitor for a ME-ARTR. I was expecting to see both inverters in the data stream but i only see one. I am...

Go to advanced search