Go to advanced search

by tmxk4197
Sat Jun 01, 2019 7:22 am
Forum: Networking and servers
Topic: How to connect LoRaWAN between LoRa node and Gateway
Replies: 0
Views: 113

How to connect LoRaWAN between LoRa node and Gateway

I am going to build a LoRaWAN environment using two dragino lora / gps HATs and two rpi3s.
Dragino shows examples using TTN, but I want to build my own LoRaWAN environment.
Does anyone know how to connect LoRaWAN between LoRa node and Gateway?
I would appreciate it if you could inform me !!
by tmxk4197
Wed May 22, 2019 1:22 pm
Forum: Networking and servers
Topic: How to make 6LoWPAN communication between LoRa (sx1278) modules.
Replies: 0
Views: 150

How to make 6LoWPAN communication between LoRa (sx1278) modules.

I would like to do 6LoWPAN communication using 2 raspberry pies and 2 Dragino LoRa / GPS Shield (sx1278). Currently I have been using the device driver for sx1278 to recognize the module (in fact, I'm not sure if the module was recognized) And I have registered the lowpan0 interface in each Raspberr...
by tmxk4197
Sat May 18, 2019 4:39 pm
Forum: Networking and servers
Topic: How can I scan between LoRa using the LoRa (sx1278) module?
Replies: 3
Views: 191

Re: How can I scan between LoRa using the LoRa (sx1278) module?

Thank you for your reply !!

If so, can I use the above API to place the same scope link address between LoRa modules?
by tmxk4197
Sat May 18, 2019 2:39 pm
Forum: Networking and servers
Topic: How can I scan between LoRa using the LoRa (sx1278) module?
Replies: 3
Views: 191

How can I scan between LoRa using the LoRa (sx1278) module?

I am using two Dragino LoRa / GPS HATs to attach to the raspberry pie and try LoRa communication. I also want to communicate LoRa over an IPv6 address. To do so, I think we should have a physical connection between LoRa. But I do not know how to do this and I do not know how to make a physical conne...
by tmxk4197
Sun May 12, 2019 12:44 pm
Forum: Networking and servers
Topic: How can I assign an address to Raspberry Pi to use 6LoWPAN with the LoRa module?
Replies: 0
Views: 92

How can I assign an address to Raspberry Pi to use 6LoWPAN with the LoRa module?

We are trying to communicate 6LoWPAN using 2 Raspberry pies and LoRa module (sx1278). After registering the LoRa module, I confirmed that the wpan0 interface was uploaded. I also confirmed using wpan-tools that the lowpan0 interface is up. After running radvd on the gateway, only the wlan0 interface...

Go to advanced search