Go to advanced search

by paulweakley
Tue May 31, 2016 10:19 pm
Forum: Troubleshooting
Topic: Networking Service Status Active(Exited) after boot
Replies: 4
Views: 4703

Re: Networking Service Status Active(Exited) after boot

So I figured out the issue, after much exploring I found that the contents of /etc/network/interfaces had only the one line for the ethernet: iface eth0 inet manual so I added these two lines above it after comparing the file to wheezy versions: auto eth0 allow-hotplug eth0 and now I haven't seen th...
by paulweakley
Sun May 29, 2016 7:41 pm
Forum: Troubleshooting
Topic: Networking Service Status Active(Exited) after boot
Replies: 4
Views: 4703

Re: Networking Service Status Active(Exited) after boot

Yes, I checked that and nothing defined in the network interfaces but I had left a fona device plugged in to the usb port so once I removed that I haven't seen the wwan in the interfaces list but the initial problem still persists. Also installed is ppp but I've had these issues even without that in...
by paulweakley
Sun May 29, 2016 4:35 pm
Forum: Troubleshooting
Topic: Networking Service Status Active(Exited) after boot
Replies: 4
Views: 4703

Networking Service Status Active(Exited) after boot

Raspberry Pi 3, JessieLite with the latest raspbian updates. Started with the version that was released May 10th. Every time I reboot the Pi I can connect via SSH for a few seconds and then the connection is lost. When connected to the HDMI I can see that the networking service exits right after the...
by paulweakley
Fri Apr 15, 2016 11:23 pm
Forum: General discussion
Topic: PiZero Roadmap
Replies: 159
Views: 64133

Re: PiZero Roadmap

I don't see any suggestions that it's BLE that they are adding to the Zero. The biggest complaint would be that adding USB components requires a splitter or a powered USB hub. Plus, the question was posed stating that it wasn't WiFi which was the major update to the Pi3 along with BLE. So it's most ...

Go to advanced search